| Gallery, Projects and General > Gallery |
| Calliper knurling tool |
| << < (2/8) > >> |
| Rik Shaw:
Hello Henning I based my version on an article and drawings by Graham Meek in "Engineering in Miniature" volume 35 - No.5 published in UK November 2013. Rik |
| Arbalist:
The Far East one I bought was very wobbly in use so I decided something more solid was needed. Not my design, just copied from others I'd seen. |
| BaronJ:
Arbalist, Your knurling tool puts my effort to shame. I've marked mine for "Must try harder !" |
| Arbalist:
Thanks, main thing is it works well enough. I would prefer to go to cut knurling but it's a bit pricey for something I don't need to do very often! |
| ksor:
Take a look at my Little program for helping find the "right" diameter for the piece you'r knurling: There is NO vira in the MSI-file ! :med: :med: |
| Navigation |
| Message Index |
| Next page |
| Previous page |