Gallery, Projects and General > Project Logs
Bench Grinder Tool Rests
rick barnes:
I really need to learn to cast. Looks good.
Fredbare:
I shall be watching this one David, looks very interesting, thanks for sharing.
John
Meldonmech:
Hi Guys
I decided to machine one base and table as far as possible on the lathe. The clamps are made off oak and perfectly adequate, and they don't mark the workpiece.
Meldonmech:
The next base and table I machined on the mill. The channel for the sliding protractor was also machined at this stage.
Meldonmech:
The protractor casting was setup level in the milling vice and machined flat using a fly cutter.
The casting was set up on the rotary table and the chamfer machined.
The clamping slot was then cut.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version