Gallery, Projects and General > Project Logs
Bench Grinder Tool Rests
<< < (2/3) > >>
rick barnes:
I really need to learn to cast. Looks good.
Fredbare:
I shall be watching this one David, looks very interesting, thanks for sharing.

John
Meldonmech:
Hi Guys

             I decided to machine one base and table as far as possible on the lathe. The clamps are made off oak and perfectly adequate, and they don't mark the workpiece.
Meldonmech:

  The next base and table I machined on the mill.  The channel for the sliding protractor was also machined at this stage.
Meldonmech:

  The protractor casting was setup level in the milling vice and machined flat using a fly cutter.
 
  The casting was set up on the rotary table and the chamfer machined.

   The clamping slot was then cut.
Navigation
Message Index
Next page
Previous page

Go to full version