Gallery, Projects and General > Project Logs

Taper attachment for mini lathe

<< < (3/3)

Meldonmech:
Hi fletch

                 Nice to see you contributing to the forum,  a neat and simple solution, involving little cost.

                                                                     Cheers David

Brass_Machine:
Nicely done! I like that.

Eric

Yorkshireman:
Hallo mfletch
Could you please tell us how you made the triangular holder for the bearings, getting it 'right' without any slack or tightness?
Thanks
Johannes

mfletch:
It just happened to be like that don't know what it was off but it's not hard to make one it can be round square any shape just do 2 bearings first then put the bar you want to use up to the 2 bearings slide the third bearing up to the other side of the bar in between the other two bearings and mark the hole make this hole slightly bigger and this gives you the adjustment to take out any slack

Navigation

[0] Message Index

[*] Previous page