Gallery, Projects and General > Project Logs
Taper attachment for mini lathe
<< < (3/3)
Meldonmech:
Hi fletch

                 Nice to see you contributing to the forum,  a neat and simple solution, involving little cost.

                                                                     Cheers David
Brass_Machine:
Nicely done! I like that.

Eric
Yorkshireman:
Hallo mfletch
Could you please tell us how you made the triangular holder for the bearings, getting it 'right' without any slack or tightness?
Thanks
Johannes
mfletch:
It just happened to be like that don't know what it was off but it's not hard to make one it can be round square any shape just do 2 bearings first then put the bar you want to use up to the 2 bearings slide the third bearing up to the other side of the bar in between the other two bearings and mark the hole make this hole slightly bigger and this gives you the adjustment to take out any slack
Navigation
Message Index
Previous page

Go to full version