| Gallery, Projects and General > Project Logs |
| Servo Driven 4th Axis for CNC Mill |
| << < (14/39) > >> |
| awemawson:
Progress :thumbup: I decided to mill the inner form of the belt drive housing, then make some hold down disk and mill the outer profile as a second operation on a spoil board. So: a/ Slice another slab of stock b/ A few passes with the roughing cutter and finishing cutter |
| awemawson:
Then make some heavy duty hold down disks and re-tram onto the correct location |
| awemawson:
And go at it again with the roughing and finishing cutters |
| awemawson:
It'll do, but there's a bit of hand blending needed where the stock wasn't quite wide enough. Next thing is to get it mounted on the servo motor and fix the encoder so that I can decide how much dishing the cover will need to accommodate the thickness of the pulleys. Bit of a delay tomorrow as all those hedging plants arrived today and need planting -it's a BIG heap :( Andrew |
| Pete.:
Nice :thumbup: |
| Navigation |
| Message Index |
| Next page |
| Previous page |