| Gallery, Projects and General > Project Logs |
| Servo Driven 4th Axis for CNC Mill |
| << < (39/39) |
| awemawson:
Peter I'm a bit tied up at the moment but a quick glance tells me that's covered round about reply #150 to this thread |
| gasmeter:
OK to answer the inhibit part of the question. MP23 is for axis IV on connector X10 0 - Ref pulse inhibit 2 - Ref pulse inhibit active A ref mark is traversed every full rotation of the sensor . If there are multiple pulses the pulse inhibit can be controlled by a cam switch or similar. I'm lucky enough to not need that as my encoder will give 1 ref pulse per rev, so I don't need pulse inhibit. Peter |
| gasmeter:
Hi Andrew I added to reply #156, so I hope that quote contains most of the info in one place to help others . Peter |
| Navigation |
| Message Index |
| Previous page |