| Gallery, Projects and General > Project Logs |
| Servo Driven 4th Axis for CNC Mill |
| << < (25/39) > >> |
| awemawson:
Well after a bit of a struggle I managed to get the unit up onto the milling table. By heck it's heavy. I fitted a bar in the chuck as a handle, moved enough junk out of the way to get my hydraulic pump up table closish, and used a bridge of 18mm mdf to slide it into place. |
| awemawson:
So now it's on the table it needs holding down - I need to make some clamps If you look closely at this picture, I've added a rear 'brace' to the swarf cover that picks up three of the bolts on the encoder belt box. This was to make it a little more rigid and stop drumming |
| awemawson:
However its not going to happen immediately as these four little piggies that I picked up this morning need dealing with |
| John Stevenson:
OOooo goody, sausages........ |
| awemawson:
--- Quote from: John Stevenson on March 11, 2014, 01:42:03 PM ---OOooo goody, sausages........ --- End quote --- I've approx 100 kGs of sausages coming back next week from the demise of Martha the sow if you need sausages . . . . :ddb: |
| Navigation |
| Message Index |
| Next page |
| Previous page |