The Breakroom > The Water Cooler
CNC pc red light and won't turn on!
Bluechip:
--- Quote from: John Rudd on January 02, 2014, 03:48:42 PM --- :worthless:
--- Quote from: Pete. on January 02, 2014, 03:22:18 PM ---Fastest way I've found to mess up a PC is use a hoover to clean it out. I've ruined two like that until I found out why.
--- End quote ---
So, what was the reason for their demise? :scratch:
--- End quote ---
Bit :offtopic: but I suppose it's because you can get a very high electrostatic charge on the plastic nozzle. When I mill plastic and vaccy up, a lot of the bits jump onto the side of the thing rather than going up th'ole. I doubt if the bits were charged as they were sitting on the mill bed which is 'sort of' earthed. Presumably it's a tribo-electric effect as the bits go up the corrugated tubey thingy ????
Dave
John Rudd:
Of course .... I should have known that :doh:
Off to kill myself......, :zap:
Bluechip:
--- Quote from: John Rudd on January 02, 2014, 05:52:25 PM ---Off to kill myself......, :zap:
--- End quote ---
Not so fast, Young Sir. T'was only a wild guess from an aged mind. ( Just loosening it up a bit with Glenmorangie. Seems to work better than Plus-Gas ... :ddb: )
Dave
raynerd:
I'm guessing my initial Hoover when the issue first arose did not help matters :-) :lol: :zap:
Doc:
Is it a laptop?
I had that problem with my laptop and I found that the latch has a switch in it that got some debris in it and it was stuck don't know how that happened :coffee: anyway cleaned it out and everything booted up and worked fine after.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version