Gallery, Projects and General > Gallery
Some tools I have built
Bishop:
If this place is like the other forums I'm a member of then we all love photos! Here are a few of the more useful tools I have built for my shop.
A small tap guide
Targential tool holder for a QCTP
Angle plate that is held in the mill vice, very useful tool.
Radius turner
ER 32 collet chuck
One more of the collet chuck
Shawn
ivansgarage:
Hi Bishop welcome,
The tap guide? looks like you have some kind of chuck that holds the taps?
What is it? four jaw?
Ivan
Bishop:
Hello Ivan
The chuck is just a small drill chuck I had lying around. I only use it for small taps and so far have had no issue with the tap spinning in the chuck.
Shawn
Arbalist:
Nice work!
75Plus:
--- Quote from: Bishop on December 15, 2013, 09:21:05 PM ---Hello Ivan
The chuck is just a small drill chuck I had lying around. I only use it for small taps and so far have had no issue with the tap spinning in the chuck.
Shawn
--- End quote ---
Shawn, Look at this thread. http://madmodder.net/index.php/topic,2289.0.html
Some of the last of the pictures shows how I went about modifying a standard tap wrench to attach to a longer shaft.
Joe
Navigation
[0] Message Index
[#] Next page
Go to full version