| The Shop > Metal Stuff |
| Welding Kart |
| << < (2/4) > >> |
| awemawson:
Just needs another bar across the front and the Plasma Cutter CAN'T go back :lol: Andrew |
| John Stevenson:
Talking of plasma cutters I needed to cut a piece of what i thought was 12mm steel for a motor mounting conversion. I have a Cebora 440v 40 A unit that is supposed to be good for 19mm. Problem is it's a pain in the rectum to get out, connect up and you get more heat off the gimbal on the electric meter than the torch. I also have one of these cheap Cut40 plasma cutters which is supposed to cut 6mm. Soooooooooooo if it cuts 6mm it will cut 12mm if you cut from both sides. Dead quick to setup, support the plate on the council dustbin because when they catch fire you just get a new one. Only got to cut a plate 200 x 230 mm. Cut from one side, turn over and repeat but it didn't fall free so quick smack with the BFH and it was on the deck. Cleaning up I measured it and it wasn't 12mm it was 15mm so dead impressed that this little inverter jobby produced the goods. |
| krv3000:
well dun john |
| doubleboost:
Hi Lads Got a bit more done John |
| doubleboost:
Hi Lads Managed a bit time in the shop today It would be a real shame to separate them Need some cable hooks and a handle now John |
| Navigation |
| Message Index |
| Next page |
| Previous page |