Gallery, Projects and General > Project Logs
New yokes
Bernd:
Looking good. That trike looks nice.
Interesting use of a tapered bearing in the first pic. :thumbup:
Bernd
Brass_Machine:
Pretty cool. So, you manually machined your triple tree? Nice. :headbang:
I didn't realize your trike front end was a double fork setup. :headbang:
Eric
DeereGuy:
Ditto what everyone else has already said. I do have one question though. In your first pic with the set up what is the tool you have in your mill? I have been trying to figure it out.
boxtriker:
thanks chap's but i stand humbled in front of what some of you can do i just stab away till i get it right and probably go about it the rong way some times but get there in the end. the tool in the mill is a boring head come fly cutter and a real handy bit of kit i got it off ebay a little time back for about 28 pound
Brass_Machine:
Just out of curiosity... when you plan your triples, how do you calculate the clamp diameter? Say off hand you are using 35mm forks. When the triple clamp is tightened up, what is the diameter of the hole for the forks? 35mm, 34mm??
Eric
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version