Oscillating spindle sander.

Gallery, Projects and General > Project Logs

<< < (3/4) > >>

S. Heslop:

--- Quote from: doubleboost on December 05, 2013, 06:20:17 PM ---Hi
Simon
Nice video
Your editing has had a massive improvement
Very well shown
John

--- End quote ---

Thanks very much. I was a little worried that i'd edited it a bit too fast and glossed over a few things though, but nobody's complained yet.

doubleboost:
You have the same problem as me
You talk to fast
The non Geordies can not keep up / understand us
John

Sid_Vicious:
As a non Geordie and not having english as my mother tongue there are sometimes a word here and there I don't understand, but it was no problem understanding you and your comments in the video. :thumbup:

S. Heslop:

--- Quote from: doubleboost on December 05, 2013, 06:38:01 PM ---You have the same problem as me
You talk to fast
The non Geordies can not keep up / understand us
John

--- End quote ---

I wish I could blame it all on the Geordie but I think i'm just a lousy speaker in general. I script alot of the commentary to try keep the ums and errs down but I have a habit of writing myself tongue twisters. I also have a hell of a time trying to say 'length' properly.

I do try speak a bit slower but it's a difficult habit for me to break when trying to break all the other habits at the same time. And don't get me started on dry mouth sounds..

Nah recording audio isn't my favourite task, but I personally do prefer audio commentary in other people's videos to subtitles.

S. Heslop:

--- Quote from: Sid_Vicious on December 05, 2013, 07:24:39 PM ---As a non Geordie and not having english as my mother tongue there are sometimes a word here and there I don't understand, but it was no problem understanding you and your comments in the video. :thumbup:

--- End quote ---

That's good to hear. I do worry about clarity because sometimes I have no idea what I'm saying myself. You should hear what my duff takes sound like.

Navigation

 Message Index

Go to full version