The Shop > Metal Stuff
Why is my lid jig a miserable failure?
Stilldrillin:
--- Quote from: Bolster on November 18, 2013, 10:05:13 PM ---Sadly, I do not have a lathe. Brass, I am curious what a 2-part die would look like. Would it be the entire circumference?
--- End quote ---
Don't forget. A mill is a lathe, standing on end...... :wave:
Good luck! :thumbup:
David D
Bolster:
--- Quote --- Don't forget. A mill is a lathe, standing on end...... :wave:
--- End quote ---
An end-standing lathe with no carriage...! Have you figured out how to add the carriage?
Stilldrillin:
The table, is the carriage.......
Install a block, with a tool mounted on top. :thumbup:
David D
DMIOM:
--- Quote from: Stilldrillin on November 19, 2013, 02:50:36 PM ---The table, is the carriage.......
Install a block, with a tool mounted on top. :thumbup:
David D
--- End quote ---
or even just pop the tool in the vice!
Stilldrillin:
--- Quote from: DMIOM on November 19, 2013, 04:33:23 PM ---
or even just pop the tool in the vice!
--- End quote ---
That's MK11 developed, already....... :thumbup:
David D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version