| The Shop > Metal Stuff |
| Why is my lid jig a miserable failure? |
| << < (3/4) > >> |
| Stilldrillin:
--- Quote from: Bolster on November 18, 2013, 10:05:13 PM ---Sadly, I do not have a lathe. Brass, I am curious what a 2-part die would look like. Would it be the entire circumference? --- End quote --- Don't forget. A mill is a lathe, standing on end...... :wave: Good luck! :thumbup: David D |
| Bolster:
--- Quote --- Don't forget. A mill is a lathe, standing on end...... :wave: --- End quote --- An end-standing lathe with no carriage...! Have you figured out how to add the carriage? |
| Stilldrillin:
The table, is the carriage....... Install a block, with a tool mounted on top. :thumbup: David D |
| DMIOM:
--- Quote from: Stilldrillin on November 19, 2013, 02:50:36 PM ---The table, is the carriage....... Install a block, with a tool mounted on top. :thumbup: David D --- End quote --- or even just pop the tool in the vice! |
| Stilldrillin:
--- Quote from: DMIOM on November 19, 2013, 04:33:23 PM --- or even just pop the tool in the vice! --- End quote --- That's MK11 developed, already....... :thumbup: David D |
| Navigation |
| Message Index |
| Next page |
| Previous page |