Gallery, Projects and General > The Design Shop

Wheels, okay then... Castors

<< < (2/3) > >>

75Plus:
Take a look at this. It may give you some ideas.

http://www.grizzly.com/products/D2260A

Joe

Dawai:
Stick two wheels out one end? put a handle on the other, lift it like a wheel barrow and roll it around. It will sit on the floor till you tilt it onto the wheels to dolly it. Warning, one chunk on the floor can cause a endo-high side.. top heavy..

S. Heslop:
Something like this could work.

http://woodgears.ca/mobile_base/table_saw.html

Maybe you could make it from steel to survive the weight.

Meldonmech:

          Simon, that is a neat way of moving a table saw.
                                                                                           Cheers David

                                 

Arbalist:
I can't help Graham but I have the same problem so if you sort it out please post some pictures. :thumbup:

My Anvil is only 1 cwt but I reckon the Oak stump it's mounted on weighs about the same!

Navigation

[0] Message Index

[#] Next page

[*] Previous page