| Gallery, Projects and General > Project Logs |
| a compound slide re fit |
| << < (2/7) > >> |
| Meldonmech:
Hi Bob Well Done, it's looking good Cheers David |
| mattinker:
--- Quote from: krv3000 on October 27, 2013, 08:43:05 PM ---ih ithink i no wat you meen you have the thum wheel then in the midel is the bolt to lock it in place when your tool is on center hite y not change the bolt for a grub scruw and mack up a dedikated alen key to fit it --- End quote --- Mine had rubber rubber washers behind the bolts, it was all soggy to adjust. I removed them, when it's slack enough to adjust, it lowers, so you have to compensate, adjust lower, then tighten, re-check, try again and if your lucky you might get it right on the third go! It's certainly better than no quick change! Regards, Matthew. |
| krv3000:
yep im changing them for a hader ruber will do a post |
| micktoon:
Hi Bob, Looking good :thumbup: , a neat job as usual, glad the slide was the one that fitted your lathe , you will be glad you spent the time doing this once you have a rack of tool holders all loaded up :drool: and will be doing your turning jobs in half the time Cheers Mick. |
| mattinker:
No rubber was much better than gooey! I'm busy with my dividing head at the moment. Curious to see what you come up with. Regards, Matthew |
| Navigation |
| Message Index |
| Next page |
| Previous page |