Thanks for all your replys chaps, i think i may not have explained the problem correctly so i will try again.
The DRO, light and power feed do not work unless the spindle is turning..i checked out the wiring again today
and the 3 above items are wired from the transformer, ie, the power feed is 110v the light 24v and the DRO
is wired to the 220v out puts from the transformer. The power to the transformer is taken from the motor
feed off the start button..
Did a test with a bit of cable to feed the tranny from it's own plug and all works ok, but waiting on Chester getting
a wiring diagram.. SO: no spindle no anything else at the moment.. Ow! and the y axis display jumps around even
with every thing locked

e-mailed them to say about that as i did not want to talk to any body just yet

Going to bolt it down in the morning...Ow! almost forgot, you will like this..put the keys in the table door turned and
pulled..nothing so pulled a bit harder...door fell off

welds broke on the top hinge but would still not turn
so i pulled the door off and will make new hinges...tis a good job i have retired and have time....I hope

Lyn.