Gallery, Projects and General > Project Logs

ball turner for a compact 8

<< < (3/4) > >>

tom osselton:
Very nice ball turner I like how you hold the tooling I've  been thinking how to put a square hole for a index marker I built.

Stilldrillin:
Very nicely done, and explained Bob!  :clap: :clap:

David D

micktoon:
Turned out lovely Bob, looks like a classy bit of tooling and will do a good job too  :thumbup: , you should have a ball handle on everything in sight by the next time I visit  :lol:

 Cheers Mick.

Meldonmech:
Hi Bob

                                          Nice job, well made.

                                                                          Cheers David       

Arbalist:
Nice one Bob.  :thumbup:

This is my one, it also has a nice big bearing in the base. Sadly I don't have tee slots on my BV20 so I had to install four tapped holes to mount it. The first thing I did on it was to make it's own ball for the handle!  :D

Navigation

[0] Message Index

[#] Next page

[*] Previous page