« previous next »
Pages: [1]   Go Down

Author Topic: Air pencil die grinder on cnc X2 for engraving  (Read 10595 times)

Offline Bishop

  • Jr. Member
  • **
  • Posts: 35
Air pencil die grinder on cnc X2 for engraving
« on: May 30, 2014, 11:44:39 AM »




Shawn
Logged

Offline raynerd

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 2911
  • Country: gb
    • Raynerds Projects - Raynerd.co.uk
Re: Air pencil die grinder on cnc X2 for engraving
« Reply #1 on: May 30, 2014, 04:20:22 PM »
Nice work Shawn  - if I had a decent compressor I`d buy one of these pencil grinders for my workshop and give it a go on my CNC.

Chris
Logged

Offline Bishop

  • Jr. Member
  • **
  • Posts: 35
Re: Air pencil die grinder on cnc X2 for engraving
« Reply #2 on: May 30, 2014, 09:18:19 PM »
Thanks Chris, your right about needing some decent air, even my bigger compressor is barely enough to run the grinder. I had another go today and I think my first results were compromised by a loose collet.  I tightened the collet up and got much better results this morning.



Shawn
Logged
Pages: [1]   Go Up
« previous next »