Gallery, Projects and General > The Design Shop

Tailstock for a Vortex dividing head ??

<< < (2/4) > >>

ksor:
The "quick & dirty" solution could be this:


But it makes it more difficult to figure out how to do the adjustments with screws, I think  :smart: :smart: :smart:

The centerblock is pivotting around and clamped with the 10mm bolt - is this realistic ? :scratch: :scratch: :scratch:

ksor:
Here it is - any comments on improvements ?

dsquire:
Ksor

If you could come up with a way to have the adjustment done with 1 screw/nut instead of 2 it would be an improvement. What you have shown should work well inspite of the 2 screws/nuts to adjust.  :D :D

Cheers  :beer:

Don

ausdier:
Just an idea.

ksor:
Yeah, real nice ... but I see a pair of problems:

1) you can't raise it high enough - OK, I can make the sides higher.

2) the "tilt" function is not posible

Navigation

[0] Message Index

[#] Next page

[*] Previous page