| Gallery, Projects and General > The Design Shop |
| Tailstock for a Vortex dividing head ?? |
| << < (2/4) > >> |
| ksor:
The "quick & dirty" solution could be this: But it makes it more difficult to figure out how to do the adjustments with screws, I think :smart: :smart: :smart: The centerblock is pivotting around and clamped with the 10mm bolt - is this realistic ? :scratch: :scratch: :scratch: |
| ksor:
Here it is - any comments on improvements ? |
| dsquire:
Ksor If you could come up with a way to have the adjustment done with 1 screw/nut instead of 2 it would be an improvement. What you have shown should work well inspite of the 2 screws/nuts to adjust. :D :D Cheers :beer: Don |
| ausdier:
Just an idea. |
| ksor:
Yeah, real nice ... but I see a pair of problems: 1) you can't raise it high enough - OK, I can make the sides higher. 2) the "tilt" function is not posible |
| Navigation |
| Message Index |
| Next page |
| Previous page |