| The Shop > Tools |
| Calculate thread pitch and feed rates... |
| << < (4/8) > >> |
| bogstandard:
That was quick John. Now I have the destructions, I will give it a dose of looking at in the morning. At the moment it definitely looks promising. I have already :poke: the suppliers, and they don't do any extra change gears for this lathe. So it looks like I need to purchase a few gear cutters. Bogs |
| Twinsquirrel:
John, looks like a great little prog, very complex to program I would imagine... :smart: :clap: :clap: :clap: :clap: nice work David |
| bogstandard:
John, Just thought I would let it do a few intitial setup calcs. After about 10 seconds it comes up with an 'out of memory' error. I actually have 4gb in this old steam powered jobbie. Bogs |
| John Hill:
--- Quote from: Darren on March 25, 2009, 05:00:50 PM ---Hi John H, that looks like you've worked hard :thumbup: If one could change the leadscrew pitch, could it work for any lathe and gear set? --- End quote --- Hi Darren, well I would have to know quite a few details, fortunately The Bogster and I have the same (near as dammit) lathe so it was easy for his. |
| John Hill:
--- Quote from: bogstandard on March 25, 2009, 05:56:23 PM ---John, Just thought I would let it do a few intitial setup calcs. After about 10 seconds it comes up with an 'out of memory' error. I actually have 4gb in this old steam powered jobbie. Bogs --- End quote --- Aw well, theres the problem, the calculated table is about 8mb, did you mean 4megs or 4gigs? Are you talking about memory or disk size? |
| Navigation |
| Message Index |
| Next page |
| Previous page |