Gallery, Projects and General > Project Logs
A junkyard lathe and mill tool grinder
vtsteam:
Thank you Don, and also Arbalist -- sorry I missed your post earlier. :wave:
:beer:
borriss:
vtsteam
You will have to tilt your table up or use the other side of the wheel in reverse to sharpen those milling cutters
Good idea you have come up with there,
Borriss
vtsteam:
Well spotted Boriss. Yes the table tilts, and will be set to the proper angle(s) when it comes time to sharpen a test mill. I just left it at the angle I had used for the lathe tool when I took the photos. There's more to do before I try it out. Thanks for responding! :beer:
vtsteam:
Restored photos after Photobucket links were broken. :beer:
SwarfnStuff:
Vsteam,
Thanks for restoring the photo links for this project. 2013 and still relevant. Only problem I have is that it has added to my ever expanding "Things to make" list.
Supposed to be 41C here tomorrow so no playpen time for this little chappy unless I can sneak out for a bit early morning.
Regards,
John B
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version