Gallery, Projects and General > The Design Shop
Gear Cutter
chipenter:
Some time ago I read an article about making gear cutters on a lathe , using two pins a set distance apart I found a program on Marv Klutz's web site that works out the size and distances for the pins and the in feed , I made a couple and they worked , looking at them I thought that they could be made on a mill with a indexing head a lot easier using an end mill , the re-leaf angles are 15 degrees as I used a 24 hole dividing ring and they work just as well .
tom osselton:
Pic's are to big for my tablet but anyone can see them if they use the view picture on their puter or tablet.
mklotz:
--- Quote from: chipenter on September 14, 2013, 02:06:48 AM --- I found a program on Marv Klutz's web site
--- End quote ---
Klotz, not "Klutz". I'm German, not Yiddish.
John Stevenson:
So if it was "Kloutz" would that be German / Yiddish ?
mklotz:
--- Quote from: John Stevenson on September 14, 2013, 07:16:13 PM ---So if it was "Kloutz" would that be German / Yiddish ?
--- End quote ---
No, that would be "clumsy bastard" typing.
Navigation
[0] Message Index
[#] Next page
Go to full version