| Gallery, Projects and General > The Design Shop |
| Gear Cutter |
| (1/2) > >> |
| chipenter:
Some time ago I read an article about making gear cutters on a lathe , using two pins a set distance apart I found a program on Marv Klutz's web site that works out the size and distances for the pins and the in feed , I made a couple and they worked , looking at them I thought that they could be made on a mill with a indexing head a lot easier using an end mill , the re-leaf angles are 15 degrees as I used a 24 hole dividing ring and they work just as well . |
| tom osselton:
Pic's are to big for my tablet but anyone can see them if they use the view picture on their puter or tablet. |
| mklotz:
--- Quote from: chipenter on September 14, 2013, 02:06:48 AM --- I found a program on Marv Klutz's web site --- End quote --- Klotz, not "Klutz". I'm German, not Yiddish. |
| John Stevenson:
So if it was "Kloutz" would that be German / Yiddish ? |
| mklotz:
--- Quote from: John Stevenson on September 14, 2013, 07:16:13 PM ---So if it was "Kloutz" would that be German / Yiddish ? --- End quote --- No, that would be "clumsy bastard" typing. |
| Navigation |
| Message Index |
| Next page |