| The Shop > Tools |
| Mini-Lathe woes |
| << < (3/5) > >> |
| Twinsquirrel:
No time like the present.... Pressing out the spindle was surprisingly easy, not the ideal setup but the best I could do with the bits and pieces laying around. Then the bearing on the motor side, luckily I had a blank which was an almost perfect fit for the outer race of the bearing with just enough clearance for the casting. And here is the unit in its component form. |
| sbwhart:
You're cooking on gas now David :thumbup: Nice job :clap: Now all you've got to do is get it back together. Stew |
| bogstandard:
Isn't it amazing David, with a little help from friends you have never met, if you had the new bits in your hands, it would be going back together again, all within a few hours from your initial cries for help. Amazing site we have here. Bogs |
| ja2on:
arc have a guide for fitting taper bearings http://www.arceurotrade.co.uk/projects/C3_BC/pages/index.html they mention a spacer that you might not be aware of |
| Darren:
Sorry David I've been out all afternoon picking up a new toy..... :ddb: I see you have pretty much got on with it whilst I had my back turned. It doesn't look like you need a puller now. But if you do get stuck the offer is always open. Just give me a shout. Let me get through the door and have a cuppa and I'll sort some info for you. |
| Navigation |
| Message Index |
| Next page |
| Previous page |