| Gallery, Projects and General > Neat Stuff |
| Clever gang tooling. =) |
| << < (2/3) > >> |
| 75Plus:
--- Quote from: BronxFigs on September 04, 2013, 08:33:30 AM ---Do you think he was cutting metal, or, plastic? The swarf looked like wax. From the video, I couldn't tell. I like. Frank --- End quote --- The upper left corner of the video says it all! Joe |
| BronxFigs:
Thanks Joe... Just clicked and watched the video. Never read the caption. How embarrassing! Frank |
| vtsteam:
Kinda interesting holding a 3 jaw chuck in a 4 jaw chuck. Guess you could use any 3 jaw without a backplate from any lathe or manufacturer, and also compensate for 3 jaw out of true as long as the jaws held axial. If doing a number of parts the same, as he is, you could be pretty sure that the 3 jaw ran true every time. Changing a part size might just mean readjusting the 4 jaw a little to suit if the 3 jaw error wasn't consistent along the scroll. Then you're back to true. Smart..... :thumbup: |
| mechman48:
Ditto Awemason.. Baaad practice! :hammer: I bet he wouldn't be doing that with aluminium or any other material so why do it at all; lucky he still has fingers :wack: George |
| AussieJimG:
Why didn't he have the turning tool and the boring bar set up at the correct distance and with a dti or stop to put him on the mark without all the measurement? Jim |
| Navigation |
| Message Index |
| Next page |
| Previous page |