Gallery, Projects and General > Project Logs

first furnace build

<< < (2/2)

Mayhem:
Looking good - thanks for posting

RobWilson:
Hi Tom


Did you get an further with your dads engine ? 



Rob

tom osselton:

--- Quote from: RobWilson on September 27, 2016, 02:59:28 PM ---Hi Tom


Did you get an further with your dads engine ? 



Rob

--- End quote ---
I haven't touched it in a while, I bought the piston rings but was not sure what size gland material or what type temperature wise, I bought some off one site and recieved what looks like yarn covered with graphite and found a place with 1/4" square high heat packing but I'd have to buy the whole roll  :doh: but I'm going to have to get back on track and carry on. I did buy a couple tools for rolling in boiler tubes off ebay just because they could be useful and had to check them out.
Mainly I have to stop playing Juan Valdez and get off my ass!  :)

RobWilson:
All in good time Tom   :proj:

I must have at least 10 unfinished projects at this moment in time  :Doh: 


Looking at the cylinder castings it looks an interesting engine .


Rob 

Navigation

[0] Message Index

[*] Previous page