Gallery, Projects and General > Project Logs
A boring table for a Craftsman 12" lathe
vtsteam:
Thanks Andrew, Tom :beer:
Today was hole day. Whole lotta holes.
I took the scale off of a 3/8" thick piece of steel plate which will cover the casting and will eventually be milled for the top groove of the t slots. I lined it and the casting up on the mill and spotted screw locations:
vtsteam:
Then started drilling tap size:
vtsteam:
Then drilled the clearance holes:
vtsteam:
Then the countersinks:
vtsteam:
Then began tapping holes:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version