| Gallery, Projects and General > Project Logs |
| A boring table for a Craftsman 12" lathe |
| << < (7/16) > >> |
| vtsteam:
Thanks Andrew, Tom :beer: Today was hole day. Whole lotta holes. I took the scale off of a 3/8" thick piece of steel plate which will cover the casting and will eventually be milled for the top groove of the t slots. I lined it and the casting up on the mill and spotted screw locations: |
| vtsteam:
Then started drilling tap size: |
| vtsteam:
Then drilled the clearance holes: |
| vtsteam:
Then the countersinks: |
| vtsteam:
Then began tapping holes: |
| Navigation |
| Message Index |
| Next page |
| Previous page |