Rob,
the dividing head is in the planning stage.
The things I want to show are a small drill bit attachment for the Clarkson and my MKI.5 Clarkson conversion, back to three phase and two speeds, toothed belt drive.
About six months ago I was finishing up the small drill sharpener, I went to try it and the magic smoke escaped. To capture the smoke was to difficult, so having a three phase magic smoke container, I've been slowly making bits to make it work. Saying all this should galvanise me into action, all I have left to do is wire the work light, mount the new (to me) relay and finish the toothed belt adjusting split cotter. I might not be able to hold back on the castings for the dividing head! Serious questions to be answered, ZA12 or Wheelium, how do I make the hold down holes fit all my machines there has to be a logic I can use!
Regards, Matthew