| The Shop > Metal Stuff |
| NeoTechs newbie melting endevours. ;) |
| << < (7/10) > >> |
| NeoTech:
Well there is many people using this type of design in some way. I just gonna do some mods to it making it easier to use. As you say its sensitive in my case crazy sensitive for small changes. I hope make it a bit more "blunt" so to speak. :) |
| Mayhem:
Thanks Ironman |
| vtsteam:
If it's burning in your burner tube -- and you don't want it to -- your gas speed in the tube where it is burning is too low. You can increase that gas speed two ways. Increase the speed of propane coming in, or decrease the diameter of your tube. A flare added to the end of a burner is basically a tubing size increase -- which allows the gas to slow and burn where you want it to -- at the end. But if your tubing is too large before that point it will burn before it reaches the flare. Then the flare is pointless. |
| NeoTech:
Hmm the tube is 28mm inside and the gas travels 25cm. So basicly shorten the tube or reduce the inner diameter until it stops acting up. Well i give it shot and go by an assortment of tube pieces. :) |
| vtsteam:
Shortening it is not what I mentioned as one of the two ways to increase the gas speed. Shortening it will shorten it. |
| Navigation |
| Message Index |
| Next page |
| Previous page |