Well you already know what's going on in the wood shop. "Stuff" is drying
So on with the clamps. First a bit of layout dye then some lines to mark hole location and finally a centre pop to locate the centre drill.
Next into the mill, I'm going to use the Grizzly mini mill for this because I don't have a holder for the smaller 1/4" end mill in the Bridgeport. I'm going to clean out that portion between the holes following the centre line and working out towards the sides to make a nice sliding fit on the table.
This picture will clear up any confusion in my writing above. The 1/8" holes are for corner clearances.
A quick bit of filing and we have a good fit on the rotary table.
Both clamps are almost done. They have had a slot cut down the centre to the 1/4" hole to help make it easier to for clamping.
A closer view from the bottom.
And here's the finished product. All clamped down and ready for some rounding over project. So stay tuned for the video coming on a forum near you………………someday after the kitchen cabinets are done.
Did I ever tell you how long it takes for polyurethane to dry ?
Regards,
Bernd