Gallery, Projects and General > How do I??

230v dc motor

<< < (2/2)

John Hill:
If it is just a single job and you don't care too much about anything a half wave rectifier (i.e. just one diode) might do the trick.

John Hill:
Doh! I forget to mention that using half wave rectification would give an effective DC voltage of something less than 230V, depending upon load and capacitance in the circuit etc.

shipto:
thanks John but I sorted it with a standard induction motor in the end, just needed to power up lathe to do a bit for the lathe drive belts. working on a new stand for it now.

Navigation

[0] Message Index

[*] Previous page