Gallery, Projects and General > Project Logs
The Artful Bodger tries to make something!
John Hill:
Yes Stew, I think that is a very good idea and not too hard to manage and I wont need a square hole if I use a round piece of tool steel. :thumbup:
I will loose my ability to machine a radius to fit the matching bit but maybe that can be tolerated (somehow).
This would certainly be more attractive than my (previously) current plan which was to have a hearty breakfast and break out the file chest, will no doubt do a better job too!
I had wanted to go about 10 mm but half that would be enough to get a secure fit, slot is about 5mm wide.
Stew :thumbup: and of course :beer:
Maybe later today (Saturday here and a few chores to get out of the way.)
sbwhart:
John
When you make the tool holder remember to drill so the tool is cutting on centre its a mistake :bang: I always make when doing that sort of job.
Good luck
and have fun
Stew
John Hill:
Bodger makes progress.....!
Fly cutter, as recommended by Stew, chops its way into the work...
Work parted off and now turning a bearing cup..
Bearing fits nicely!
Tried for size on a gimbal ring.
Doesnt look too bad, even if I say so myself!
sbwhart:
That looks real cool :thumbup: :clap: :wave:
I can see what your making now John.
:ddb: :ddb: :ddb: :ddb:
More More More.
Stew
kellswaterri:
Hello John, now a litttle less ''confuddled''that I can see what you have made...very good job too...
All the best for now,
John
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version