| Gallery, Projects and General > Project Logs |
| The Artful Bodger tries to make something! |
| << < (5/10) > >> |
| John Hill:
Yes Stew, I think that is a very good idea and not too hard to manage and I wont need a square hole if I use a round piece of tool steel. :thumbup: I will loose my ability to machine a radius to fit the matching bit but maybe that can be tolerated (somehow). This would certainly be more attractive than my (previously) current plan which was to have a hearty breakfast and break out the file chest, will no doubt do a better job too! I had wanted to go about 10 mm but half that would be enough to get a secure fit, slot is about 5mm wide. Stew :thumbup: and of course :beer: Maybe later today (Saturday here and a few chores to get out of the way.) |
| sbwhart:
John When you make the tool holder remember to drill so the tool is cutting on centre its a mistake :bang: I always make when doing that sort of job. Good luck and have fun Stew |
| John Hill:
Bodger makes progress.....! Fly cutter, as recommended by Stew, chops its way into the work... Work parted off and now turning a bearing cup.. Bearing fits nicely! Tried for size on a gimbal ring. Doesnt look too bad, even if I say so myself! |
| sbwhart:
That looks real cool :thumbup: :clap: :wave: I can see what your making now John. :ddb: :ddb: :ddb: :ddb: More More More. Stew |
| kellswaterri:
Hello John, now a litttle less ''confuddled''that I can see what you have made...very good job too... All the best for now, John |
| Navigation |
| Message Index |
| Next page |
| Previous page |