Gallery, Projects and General > Project Logs |
A engine by 3 amigo's |
<< < (2/8) > >> |
vtsteam:
They look great!! :thumbup: |
micktoon:
Hi Bob , I bet that took some buffing by hand :palm: , its harder work than you would think before you start, I have a floor standing buffer here if you wanted to do a few bits at once mate . Keep up the good work . Cheers Mick |
Stilldrillin:
Hi Bob. Just the sort of thing I love to do! :D No!! Not the polishing...... Rebuilding, and improving someone else's efforts! :thumbup: You're off to a great start! :clap: :clap: David D |
krv3000:
thanks all for the coments buffing by hand ant that bad mick all you need is difrent grades of sand paper the wet and dry type to start with then rubing bloks they a over grown ruber with grit inpregnated in to the ruber then good old brasso |
krv3000:
hi all well i did a bit more tonight i have modded the oilier that rob had made the tubing is two old bubbles from a spirit level first thing i did was to cut off the top part of the original oilier the reason for this is the thread is BA and i don't have any of them + way remake something that's OK i then had to mack a ring to go over the remaining part to form a collar for the tube to sit in and that was silver soldered on to the bottom SOS no pics of that bit i then direst the center out i then drilled the hole bigger in the middle to 3mm for a center tube i then tappet sum m3 tubing with a m3 thread then drilled sum 1.3 mm holes a round the bottom then this was soft soldered in too the bottom i then made the top with a 5mm hole in then made a bush tapt m3 then turned dawn to m5 to fit in to the top cape then this was silver soldered in to place right pics |
Navigation |
Message Index |
Next page |
Previous page |