| Gallery, Projects and General > Gallery |
| Quickie true up |
| (1/1) |
| mechman48:
Hi all :headbang: Had a couple of hours spare yesterday so decided to 'potter' in the workshop; stuck a couple of storage trays up next to my lathe for round stock.. scrap guttering from double glazing firm skip, then wondered what else to potter with :scratch: then it hit me, I remember putting away the reclaimed bearing from my bandsaw repair & said to 'mesel' what was I going to do with that :scratch: ; AHA! I sez' so I drilled & tapped a piece of 12mm sq. ally offcut for 8mm, machined a scrap 10mm bolt from the odds 'n' sods box to be a press fit in to the bearing, pressed the bearing on & 'voila! a quick true up device. tested it on a small bolt held in the 3 jaw, worked a treat, did the same on a thin washer .. spot on.. :thumbup: now no need to set up a DTI for quickie jobs. I know a lot of you have done similar & it's not a new idea as there are many versions on this & other forums but it's another addition to my 'home made' tools that 'I made outa bits'. Thanks & credit to the originator, & others, for the idea. |
| Meldonmech:
Hi George, That little item will save you lots of time setting up. Cheers David |
| Navigation |
| Message Index |