| Gallery, Projects and General > How do I?? |
| fly cutter |
| << < (9/13) > >> |
| wongster:
Hi cidrontmg, Any idea is those cup type got to use with different type of grinder? Regards, Wong |
| Stilldrillin:
Wong, I use a 50mm dremel type, diamond disc........ Works well, for me! :thumbup: David D |
| cidrontmg:
--- Quote from: wongster on August 25, 2010, 01:43:03 AM ---Hi cidrontmg, Any idea is those cup type got to use with different type of grinder? Regards, Wong --- End quote --- Hi Wong, I use my cup wheel in a 20 Chinese grinder, for the time being at least. Iīve been thinking of making a more elaborate tool grinder, but not yet done much about it. Collected some parts. Another project for the future... I obviously needed to take off the wheel protection. Thatīs not any danger, the diamond cup is aluminium, so it wonīt shatter (donīt take the protection off with any "stone" wheel, though!). Also, I needed to turn a spacer and a washer for the cup wheel, it has a bigger hole than the grinder axle. Just some aluminium bar stock, nothing fancy. But reasonably accurate, so the cup wheel runs as true as you can get it. Thereīs also a small table to hold the tool piece. The wheel cuts with its "outward" side, so the table is towards that end. Tried uploading pictures to Photobucket, got this "Photobucket Site Maintenance Images and videos may continue to serve during this short maintenance." So some pics and notes here. The grinder tables rust in an instant when they get wet from the water-cooled tool bit... Just surface rust, but they donīt look nice. The diamond wheel table is rather flimsy, but has served its purpose. I should have built something looking more like the other end table, but contemplating about a far more elaborate tool grinder has put that table on hold... Function comes before good looks, and I like ball handles... |
| wongster:
--- Quote from: fatal-exception on August 24, 2010, 10:37:06 PM --- The black line near the tip is some built up HDPE plastic that I didn't notice when I took the picture. --- End quote --- Can I say that the black line is the edge that was doing the cutting? Mine was further up to the left (the straight part) of the cutter in your pic. Could be the angle of my holder. |
| wongster:
--- Quote from: Stilldrillin on August 25, 2010, 02:20:05 AM ---Wong, I use a 50mm dremel type, diamond disc........ --- End quote --- Hi David, The block behind - wood? Regards, Wong |
| Navigation |
| Message Index |
| Next page |
| Previous page |