| Gallery, Projects and General > Project Logs |
| A lay shaft reducer for the 7x14 lathe. |
| << < (2/4) > >> |
| John Rudd:
Cracking job I think... :thumbup: despite the comments... You go ahead and do your own thing Abe...great entertainment. :clap: |
| doubleboost:
Great looking mods Very well shown I have a couple of big gudion pins as well John |
| krv3000:
well dun good job |
| modeldozer:
Hi John, john and krv3000, Thanks for the encorragement. Abraham |
| modeldozer:
Hi all, While I am waiting for the belt and pulleys to arrive I made the rear headstock support Machined a piece of 10mm plate square and did a cutout in one side. Made a half moon cutout at the top to go around the gear change lever. The two pieces that will make up the support. Drilling the holes to bolt the two together. Set up the smaller piece and cut a chamfer at the outer top. Drilled the holes to bolt it to the headstock, and a large hole for the cables to pass through. And fitted to the lathe. At the bottom it bolts to the heavy channel the lathe bed is bolted to. Cheers Abraham, |
| Navigation |
| Message Index |
| Next page |
| Previous page |