Gallery, Projects and General > Gallery
Miniature Tool Collection
flyingtractors1:
Here is the second model - this one with the offset diagonal jaw done in polished sterling silver and left untoned. Ralph
tom osselton:
You sure do nice work alway's a pleasure to see your projects.
flyingtractors1:
Thanks, Tom. I appreciate your thoughts. Ralph
flyingtractors1:
I typically work in 1/4 scale but thought I'd do a piece in 1/3 scale based on an actual wrench that is 8 inches. The 1/4 scale is posted above, and here is a pic of both and the wooden prototype for comparison. Ralph
vtsteam:
In catching up with this thread I happened to open it at the vise above, and was amazed at the coincidence! Yesterday I saw the very same type of iron miniature vise and even picked it up to look at it better. I'd never seen one before like that, though I once owned a full size blacksmith's vise.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version