Author Topic: types of threads  (Read 9200 times)

Offline tom osselton

  • Hero Member
  • *****
  • Posts: 1255
  • Country: ca
types of threads
« on: April 13, 2013, 03:30:20 AM »
 Im not sure where I should post this but felt it would be useful to bookmark   http://www.gewinde-normen.de/en/index.html

Rob.Wilson

  • Guest
Re: types of threads
« Reply #1 on: April 13, 2013, 03:56:11 AM »
Well worth bookmarking Tom ,,,,,,,, thanks for sharing  :thumbup:



Rob

Offline John Rudd

  • Hero Member
  • *****
  • Posts: 2525
  • Country: gb
Re: types of threads
« Reply #2 on: April 13, 2013, 08:09:54 AM »
Nice find.. :thumbup:

Interesting that there's actually a Whitworth fine thread......... :scratch:
eccentric millionaire financed by 'er indoors
Location:  Backworth Newcastle

Skype: chippiejnr

Offline Bluechip

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 1513
  • Country: england
  • Derbyshire UK
Re: types of threads
« Reply #3 on: April 13, 2013, 08:28:31 AM »
Another screwy thing here:
 
http://www.watchman.dsl.pipex.com/thread.html
 
Better to download the EXEL file, then it can be column sorted.
 
BC
 
I have a few modest talents. Knowing what I'm doing isn't one of them.

Offline John Rudd

  • Hero Member
  • *****
  • Posts: 2525
  • Country: gb
Re: types of threads
« Reply #4 on: April 13, 2013, 10:27:02 AM »
Nice find Dave  :bow:

but I cant see me wanting to thread a 10 W.INS.... :dremel:  Bit toooooo   small methinks
eccentric millionaire financed by 'er indoors
Location:  Backworth Newcastle

Skype: chippiejnr

Offline Lew_Merrick_PE

  • Hero Member
  • *****
  • Posts: 690
  • Country: us
Re: types of threads
« Reply #5 on: April 13, 2013, 12:13:40 PM »
If you go to http://quicksearch.dla.mil/ you can download virtually any U.S. military (unclassified) specification.  FED-STD-H28 is the source authority for screwthreads for U.S. government work.  It contains more information on screwthreads than anybody in their right mind (i.e. nobody here qualifies, right?) wants to know.  The drawback is that you have to know the ID number of the document in question.  FED-STD-H28 is the ID number.

Offline piper1

  • Jr. Member
  • **
  • Posts: 61
  • Country: gb
Re: types of threads
« Reply #6 on: December 16, 2013, 05:58:35 PM »
Thank you very informative.

Offline Arbalist

  • Hero Member
  • *****
  • Posts: 673
  • Country: gb
Re: types of threads
« Reply #7 on: December 17, 2013, 11:18:17 AM »
Hhm, I won't be bookmarking this as I'm not sure if I can trust the data. The tapping drill sizes for Metric Coarse are different from any other data charts I've seen for this series. I've had lots of thread charts over the years and some have different drill sizes dependant on percentage of thread engagement but this is completely different.