| The Shop > Tools |
| Making Simple QC Tool Holders |
| << < (12/21) > >> |
| vtsteam:
All pilot drilled. |
| vtsteam:
Drilling 5/16" to 1-3/4" depth for threading. After that I drilled 3/8 to 1" for the clearance hole. But this turned out to be a mistake. The 3/8" x 16 TPI tap wouldn't fit in the clearance hole. I measured the 3/8" drill bit and it was .372" -- the tap was .376" so no go. I had to re-drill all blocks to 25/32" to clear the tap. |
| vtsteam:
Tapping 3/8-16. |
| vtsteam:
Clamp bolt holes all tapped. |
| vtsteam:
Slitting (with the newly cleaned up milling vice!). |
| Navigation |
| Message Index |
| Next page |
| Previous page |