The Shop > Tools
Making Simple QC Tool Holders
vtsteam:
Drilled through 3/8".
vtsteam:
Next drilling to 5/8".
vtsteam:
Keeping corners always aligned helps me remember. I really don't want to move the wrong chuck jaws or insert the blocks wrong way round.
vtsteam:
Last drilling operation. The largest drill I had was an odball 1-1/32". don't know where I picked that one up from! I clamped it with vice grips to keep it from turning -- they rest on the top slide (out of view). The blue marks on the chuck are at Jaws 1 and 4.
vtsteam:
After that was done it was time to switch to the boring bar. I took pretty healthy cuts because I was getting, well.....bored.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version