| Gallery, Projects and General > How do I?? |
| Reaming Blind Holes? |
| << < (4/4) |
| DavidA:
Dave and David, My Red Lathe has two taper pins to locate the leadscrew support bearing housing plus two screws to hold it tight to the bed. The taper pins protude slightly so I can get a hold of them with mole grips and pull them out if I need to remove the housing. As they are for location only, I don't knock the pins in too hard. Dave. |
| Pete W.:
I'm amazed that this thread is still getting replies - thank you all very much. :beer: :clap: :beer: :clap: :beer: :clap: |
| Navigation |
| Message Index |
| Previous page |