Well,
when I started almost a year ago, it looked like this
then I began with hole lot of mods....
had made a new 100 mm spindle, extended a bit
had problemns with removing old pulley
and managed to burn the board, but had it repaired
did a mod for easy angle setting - made a carrier of hardened steel, cause the old one got nicked quite quickly
and made these ones from bronze, for easy sliding
and drilled a hole for carriage stop, that works
part underneath isnt attached on pic
slide is now on acme thread
throug these ones with bearings
metal pulley with 14 cogs
new tailstock from Amadeal
and milling and ball turning attachments from LMS
qctp is also from Amadeal (sold it in the meantime and ordered one from LMS)
new "wheels"
then, I have managed to brake the plastic gears inside headstock, replacement ones - metal of course, came in today, from Amadeal. With 550 W motor
Didnt make the pics yet, I will do it in next few days. Along with new QCTP from LMS, metal change gears are on route too. So every plastic piece will be changed
On this new motor, I will fit a 12 cogs metal pulley. I think I will have a lot of torque. I just hope that my KBLC240D will work with it without problems. And also, I have to figure out how to fit the motor there, because there isnt enough room to do it.