| Gallery, Projects and General > Project Logs |
| Mrs. Robinson, Revisited....... |
| << < (9/14) > >> |
| Stilldrillin:
Eyebrows still intact Rob! :) It all went very well, considering. :thumbup: Sensible maximum........ Sensible minimum....... Turned right up...... With those blue tips being blown upward, I think we need some more holes! Mid setting. It ran the engine perfectly! :ddb: :ddb: A bit of cosmetic work to do on the pot, and drill some more holes..... Job's a good un! :D David D |
| vtsteam:
Wow, excellent burner! Nice looking, too. Congratulations! :thumbup: :clap: |
| Rob.Wilson:
Your cooking with gas now David Thats a nice blue flame :clap: :clap: :clap: :clap: Rob |
| Stilldrillin:
VT, Rob. Thanks Chaps! :beer: Drilled a few extra holes. Some of them, larger diameters. Until testing showed all the little blue flames were where they should be. :thumbup: So, I reduced the oal height to 1/2", painted and finish assembled...... I'm a bit pleased with my first attempt at making a burner. :) David D |
| Stilldrillin:
Well....... I'm still here! :wave: Unfortunately, shop time and enthusiasm have been hard to find recently. :( But, I've sourced a rubber wood base, and gas tank...... It runs ok, so far....... Trying to get me head around plumbing the water tower. It needs up/ down pipes. I intended to solder direct into the side. But, don't like that idea, now........ Cos it needs to unplug from the engine stubs...... Thought, mebbe I could solder in, boiler type bushings. Then plumb lower pipe through a 90* elbow, and upper, bend to horizontal....... Anyone else got a better idea? :scratch: Are there any better looking, 8mm dia fixings, than these? It's nice to be back! :thumbup: David D |
| Navigation |
| Message Index |
| Next page |
| Previous page |