| Gallery, Projects and General > Project Logs |
| Oh Blimey I bought a CNC Lathe !!!! |
| << < (59/134) > >> |
| awemawson:
Then guillotined the easy bits, remembering to cut strips from the waste for the thickening at edge while it's still big enough to hold. The other cuts had to be with a thin angle grinder disk |
| awemawson:
I decided to spot weld the strips to the edge but these tips need a clean up: |
| awemawson:
A quick trip to the lathe did the job: |
| awemawson:
I made a few test welds with some scrap of the same thickness to make sure the spot was properly welded but not too unsightly adjusting the welding time between welds: |
| awemawson:
Then clamp it up and weld it: |
| Navigation |
| Message Index |
| Next page |
| Previous page |