Gallery, Projects and General > Project Logs

Minnie TE Long term project

<< < (16/49) > >>

R.G.Y.:
 :DAs you have seen Joe I took the soft option, went with rubber tyres.  R.G.Y.      :clap:

Joe d:
RGY

I decided to go with the strakes, can always stick some rubber tyres on top of them if needed,
whereas I know that I would likely never go back and do the strakes if I didn't put them on now :D

Joe

R.G.Y.:
My Minnie has come to a halt, having trouble (a lot) with my mill. Unable to proceed with the engine. 

Joe d:
Well, that would be rather annoying.  Mason seems to have done his milling with a vertical slide on his lathe,
maybe you could get at least some stuff done that way?

Joe

R.G.Y.:
Yes Joe I have the book. Unfortunately my vertical slide will only fit across the slide. I have two options. Cut the bottom off the v.s. ,or fix it to a .5" plate to raise it up. Then the bit that projects over the edge of the cross slid will clear.GEOFF

Navigation

[0] Message Index

[#] Next page

[*] Previous page